- 您现在的位置：买卖IC网 > Sheet目录325 > FAN7346MX (Fairchild Semiconductor)IC LED DRVR 4 CHAN BLU 28SOIC
7. Over-Voltage Regulation (OVR)
To prevent LED driving voltage from exceeding the
withstanding voltage of system components, the
FAN7346 controls LED driving voltage with OVR pin
voltage. The FAN7346 senses output LED driving
voltage through the OVR pin voltage. Resistor divided
output voltage is applied to the OVR pin voltage.
In FAN7346, OVR voltage uses two kinds of feedback
and control: and regulating output voltage during enable
off and clamping output voltage during enable on.
When ENA pin is LOW, the FAN7346 controls FB voltage
to maintain OVR voltage as 1.0V. Through this output
voltage control during ENA off, the FAN7346 reaches
adequate LED driving voltage before turning ENA on.
After ENA pin is HIGH, OVR pin voltage is used for over-
voltage regulation. If OVR pin voltage is lower than
1.42V, the FB pin voltage follows headroom control to
maintain minimum voltage of drain voltages as 1V. If
OVR pin voltage is higher than 1.42V, the FAN7346
controls FB (FB is pulled LOW). Through feedback
regulation, OVR pin voltage cannot exceed 1.42V.
8. Over-Current Protection (OCP)
Through over-current protection, the FAN7346 can
protect external balance switches from shorted over-
? 2011 Fairchild Semiconductor Corporation
FAN7346 ? 1.0.0
13
current damage. To sense over-current condition, the
FAN7346 monitors FBx (FB1~FB4) pin voltage.
If FBx voltage is higher than 1V for 20μs, CHx is
considered an over-current condition. After sensing OCP
condition, CHx dimming switch is turned off.
OCP is channel individual and latched protection. If one
channel is in OCP condition, other channels keep
operating. OCP channel is restarted after UVOL is reset.
9. Error Flag (FO)
To make error flag signal, the FAN7346 uses the FO pin.
FO pin is open-drain type.
During normal operation, the FO pin is open. If using an
external pull-up resistor, this signal is HIGH.
If used OLP / OCP / SLP protection, the FO pin is
connected to ground. If using an external pull-up resistor,
this signal is LOW.
If a single channel is in protection condition, error-flag
signal is detected. Only if all channels are operating
normally is the FO pin pulled HIGH.
www.fairchildsemi.com
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
FAN73611MX
IC GATE DVR HIGH SIDE 1CH 8-SOIC
FAN7361MX
IC GATE DRIVER HIGH SIDE 8SOIC
FAN7362MX
IC GATE DRIVER HIGH SIDE 8SOP
FAN73711MX
IC GATE DVR HIGH SIDE 8-SOP
FAN7371MX
IC DRIVER GATE HIGH SIDE 8SOP
FAN7380MX
IC DRIVER GATE HALF BRIDGE 8SOIC
FAN7382M1X
IC GATE DRIVER HI/LO SIDE 14-SOP
FAN73832MX
IC GATE DRIVER HALF BRIDGE 8-SOP
相关代理商/技术参数
FAN7346MX-CUT TAPE
制造商:FAIRCHILD 功能描述:FAN7346 Series 4 Channel LED Driver String Balancer w/ Dimming LED Load Control
FAN7361
制造商:FAIRCHILD 制造商全称:Fairchild Semiconductor 功能描述:High-Side Gate Driver
FAN7361_07
制造商:FAIRCHILD 制造商全称:Fairchild Semiconductor 功能描述:High-Side Gate Driver
FAN7361_09
制造商:FAIRCHILD 制造商全称:Fairchild Semiconductor 功能描述:High-Side Gate Driver
FAN73611
制造商:FAIRCHILD 制造商全称:Fairchild Semiconductor 功能描述:Single-Channel High-Side Gate Drive IC
FAN73611M
功能描述:功率驱动器IC HI-SPEED GATE DRIVER RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube
FAN73611MX
功能描述:功率驱动器IC HI-SPEED GATE DRIVER RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube
FAN7361M
功能描述:功率驱动器IC High Side Gate Driver RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube